Episode 4 3/3 - Reflow, Wave Soldering, Testing and Conformal Coating: The Final Steps

Video hosted by YouTube: playing it here means accepting YouTube's cookies.

Watch on YouTube

Final part of our tour of the Eiffage Énergie Systèmes factory in Verquin with Charlie Vandaele: the steps that give the board its final form and full functionality.

On the agenda: double reflow to assemble both sides, X-ray inspection, wave soldering for through-hole components, then panelization, fiducials and board depaneling. Charlie also explains why an oversized panel is a problem: stretch, the slight expansion of the PCB as it goes through the oven, shifts the paste deposit on the next pass, and it cannot be corrected.

Each board is then checked with a flying probe test and on a test bench, before manual rework, the conformal coating that protects circuits in the harshest environments, and shipping. Charlie wraps up with LEAN, the NPI review and the constraints designers benefit from anticipating.

Episode chapters

Click a timestamp to play the video from that point.

  • 0:00 Introduction
  • 1:17 Double reflow
  • 8:12 Two SMT lines
  • 8:58 X-ray inspection machine
  • 10:06 Through-hole components
  • 13:07 Panelization
  • 14:43 Fiducials
  • 17:19 Stretch: expansion of large panels
  • 19:51 PCB depaneling
  • 21:56 Inspection and flying probe test
  • 25:43 Test bench
  • 27:58 Customer-specific requirements
  • 29:11 Manual rework, conformal coating and shipping
  • 32:54 Top 5: LEAN
  • 42:30 Integration
  • 43:10 NPI review
  • 43:50 Anticipating constraints
  • 45:22 How to contact them

Paid partnership: thank you to ICAPE for supporting the Dans les coulisses du PCB podcast.