Episode 4 3/3 - Reflow, Wave Soldering, Testing and Conformal Coating: The Final Steps
Video hosted by YouTube: playing it here means accepting YouTube's cookies.
Final part of our tour of the Eiffage Énergie Systèmes factory in Verquin with Charlie Vandaele: the steps that give the board its final form and full functionality.
On the agenda: double reflow to assemble both sides, X-ray inspection, wave soldering for through-hole components, then panelization, fiducials and board depaneling. Charlie also explains why an oversized panel is a problem: stretch, the slight expansion of the PCB as it goes through the oven, shifts the paste deposit on the next pass, and it cannot be corrected.
Each board is then checked with a flying probe test and on a test bench, before manual rework, the conformal coating that protects circuits in the harshest environments, and shipping. Charlie wraps up with LEAN, the NPI review and the constraints designers benefit from anticipating.
Episode chapters
Click a timestamp to play the video from that point.
- 0:00 Introduction
- 1:17 Double reflow
- 8:12 Two SMT lines
- 8:58 X-ray inspection machine
- 10:06 Through-hole components
- 13:07 Panelization
- 14:43 Fiducials
- 17:19 Stretch: expansion of large panels
- 19:51 PCB depaneling
- 21:56 Inspection and flying probe test
- 25:43 Test bench
- 27:58 Customer-specific requirements
- 29:11 Manual rework, conformal coating and shipping
- 32:54 Top 5: LEAN
- 42:30 Integration
- 43:10 NPI review
- 43:50 Anticipating constraints
- 45:22 How to contact them
Paid partnership: thank you to ICAPE for supporting the Dans les coulisses du PCB podcast.
Episode 1 - Christian Maudet (Thales): Standardizing Printed…
Episode 2 - Designing a Cellular and Satellite GPS Tracker: …
Episode 3 - French PCB Manufacturing Versus Asia: Marc Simon…
Episode 4 1/3 - Inside the Eiffage Factory: From Order to Co…
Episode 4 2/3 - How an SMT Line Works, from Solder Paste to …
Episode 4 3/3 - Reflow, Wave Soldering, Testing and Conforma…
Episode 5 1/2 - The Challenges of an EMS Provider: Mistakes,…
Episode 5 2/2 - Design for Assembly: BGAs, Via-in-Pad, Surfa…
Episode 6 1/2 - Millomaker: The Hidden Work Behind the Elect…
Episode 6 2/2 - Millomaker Answers Your Questions
Episode 7 - Can French Electronics Be Saved? Sébastien Rospi…
Episode 8 - Why Learning Electronics Has Become Essential